"Davisco metalworking pushed us, quite honestly," allows Jack Jordan, president of Sudmo. "Somebody had to sit down and redesign a valve to handle particulate, and that''s a big challenge. But the ability to handle particulate up to 1.5 inches opens up complete new mini drill press markets for us." fruit for yogurt, soups and pet foods are among the processing segments evaluating press the technology.another innovation that must pass sanitary muster before it can find wide application in food processing is the constant flow (cf) valve from gate llc. the valve was developed by john newton, a florida inventor and founder of grand banks yachts, at the request of e.i. dupont de nemours to improve the accuracy of chemical metalworking spraying in agriculture. accurate depositing is easy to achieve if pressure is constant, but that is not always the case. the cf valve offers a simplified design drill and preset calibration to precisely press and metalworking and drill dispense liquids or gases.

the press center-rear location is typically the best spot, but the generator metalworking may be placed on the side of the body depending on weight. nfpa 1901 talks about drill load distribution and keeping the side-to-side load variation to no more than 7% of the tire or axle weight rating. gas or diesel press and metalworking generators with fuel drawn from the cab/chassis fuel tank also are available.if these generators take up too much weight and space drill on the truck, consider an under-hood belt-driven or power take-off generator. these generators are lighter and won''t add noise on scene, create additional heat press or take up usable compartment storage areas. best of all, they require little or no maintenance.

©2003 www.drill-press.net All rights reserved.