Rotary Table--Gardner Denver 37 1/2".DERRICK: Branham 147''; 1,392,000-1b hook load capacity.BOP SYSTEM: Three Cameron type U 10,000psi BOP; 5,000 psi Hydril; 20" Regan diverter.CRANES: Two SeeKing 1400.REMARKS: Formerly Griffin-Alexander III.WORK AREA: Bombay High.ABAN IIIRIG DESIGN: Marathon LeTourneauCONSTRUCTION: Marathon LeTourneau Offshore Pte.Ltd., Singapore, 1974, Modified to cantilever 1984.PERFORMANCE: Water depth--300''; Drilling depth--20,000''.QUARTERS: 94 persons.HULL: LeTourneau design 230'' x 200'' x 26''.

Mohawk Lifts model TSL-7 is a 7,000 drillpress-sprunger lb. capacity twin scissor lift. The TSL-7 Pad lift is available with four fully drillpress-sprunger rotating swing arms, as well as a variety of rubber blocks to make contact with all vehicle lifting points. Available as a "flush mount" lift, the lift recesses into the drillpress-sprunger concrete of the shop floor to maximize repair bay space. The Mohawk TSL-7 fits in the narrowest of bays. Mohawks TSL-7 has a low 7-3/4 in. profile, with shallow angle approach ramps which allow even the lowest riding sports cars to be raised. Equipped with a 12-position locking system on both scissoring legs, twin hydraulic cylinders and operates on 208/240 volt single or three phase power. Mohawk Lifts If you''re serious about swapping the urban rat race for a life of frugal, back-to-the-land self-sufficiency, the right equipment will make the difference between paradise and peril. We looked back on 30 years of building, tilling, harvesting and fence stringing to come up with the following list of essential tools we wish we''d had when we first stepped off the well-paved map and went homesteading.

The feature enhancements begin up-front with the new 60 Series combines. A new fore/aft tilt-frame feederhouse is standard on all machines - drillpress-sprunger except the Sidehill combine. The 17-degree fore-aft-tilt-angle allows for proper positioning of the platform and insures that the cutter bar runs parallel to the ground for all tire sizes.Proper positioning of the cutterbar prevents knife guards from bulldozing or the platform from skidding on its rear frame. A simple draw bolt adjustment on the feederhouse is quick and easy and the pivot point is located in the center of the tilt frame for a proper angle to maximize the feeding of crop into the feederhouse throat.

©2003 www.drill-press.net All rights reserved.