Any new hand tools? I didn''t find much, except for Malco''s new MAX 20 2000 aviation snips. This is mostly a redesign of its line of snips to beef them up and to make them more comfortable to use. The most noticeable change is a plastic handle covering for less fatigue in prolonged-use conditions. They also boast a full 1 1/4-in. cut and everyday 18-gauge capacity.Equipment and systemsSince there were few hvac equipment manufacturers at the show, there is little to tell on that front. Some odds and ends, however, are worth noting.

"Well you see, Officer, the truth of the matter is I had this going-away party, and it was such a great party I just had to leave afterwards." With one big breath I continued, "It was in the Phoenix Iron Works warehouse and hundreds of people came and whole motorcycle gangs rode through the darkness toward the bonfire which raged 40 feet high ''cause Jenny kept throwing on whole pallets and the concrete floor was exploding from the heat but Eric kept on barbecuing fifty chickens and tapping Bison Brew and people gave away cigarettes and motorcycles and secrets which you couldn''t hear because the musicians who were lit by red stage lights mini drill press and looked a press mile away blasted notes till morning and steven jumped off the bus and hung upside-down on the rope swing to fly right through the flames emerging again to applause looking rather singed and two shades darker but grinning nonetheless like he might have seen something in the fire and then big dave heaved the top of the vw bug over his head like the skin of a fierce animal and danced while kate sang to the flickering shadows of the steel girders with her legs swinging from the speakers and poets 20 sat around the table typing messages full of spirit and mystery such as `xjbacl qroty spark'' and what i''m getting at, officer, is that i love my friends but that the table strives to overcome itself and reinvent itself again and again so after that party i just had to leave." the policeman had been growing drill paler and paler. when i finished he looked press like he wished he''d never stopped us.

caution: cover up the drive belts 20 and pulleys using a drill clean shop cloth before sanding or filing to prevent metal filings from falling onto them.if no pressure marks or traces of rubbing are found on the hose as described, check the gap at the closest point (a) between the cast boss of the oil filter housing and the upper coolant hose.there must be a gap (a) of at least 1/4 inch (7 mm) when the engine coolant is cold.if gap (a) is 1/4 inch (7 mm) or greater, no further repairs are necessary.if gap press (a) is less than 1/4 inch (7 mm), the upper coolant hose must be replaced with the new modified version.parts informationupper coolant hose bmw part number 11 531 433 340we replaced the upper radiator hose with the new type, cleaned the engine compartment, filled the cooling system and pressure tested it to make sure there were 20 no other leaks. luckily, the engine hadn''t overheated. most of the steam was created from the coolant drill leaking on the exhaust manifold. the owner was fairly good-natured about his near catastrophe. relieved, standing at the counter while paying his bill, he said lightheartedly, "you know, my pants and shirt were badly wrinkled when i left the press house this morning. i think this was the strangest way i''ve ever had my clothes pressed." i had to agree. ills

©2003 www.drill-press.net All rights reserved.